WAGO 222-415 Splicing connector

WAGO · Splicing connector

222-415 is a WAGO Splicing connector. Operating temperature: +40 °C; Rated voltage: 400 V; Rated current: 32 A; Rated surge voltage: 4 kV. It is used in control panels, machine builds and spare-part replacements where the installed unit is matched to the original catalog number and a documented part is required.

• Operating temperature+40 °C
• Rated voltage400 V
• Rated current32 A
• Rated surge voltage4 kV
• Clamping units5

Specifications

Values follow the WAGO official technical data published for catalog number 222-415; parameters not confirmed for this variant are omitted rather than estimated.

Model comparison in the same family

Before selecting an alternative, confirm its dimensions, terminals and installation requirements in the manufacturer documentation.

Where it sits in the control system

The 222-415 is the device-level element in a WAGO Splicing connector installation. It receives the field signals and control supply listed above and switches or conditions the load within the ratings shown in the Specifications table. Wiring and protective devices are sized against operating temperature +40 °C, rated voltage 400 V, rated current 32 A — not against a generic assumption.

Typical installations place it in control panels, machine builds and spare-part replacements, where the unit is matched to the original catalog number and the enclosure provides the mounting support listed above. Record the catalog number and revision from the nameplate of the installed unit before specifying a like-for-like spare.

Selection notes for WAGO 222-415

WAGO 222-415 — WAGO industrial component supplied as a like-for-like replacement, selected by catalog number and published ratings. The figures below are taken from the WAGO official specification for catalog number 222-415; always cross-check the catalog number and hardware revision on the nameplate before placing an order.

• Operating temperature: +40 °C — Verify it in the project documentation before confirming the order.
• Rated voltage: 400 V — Verify it in the project documentation before confirming the order.
• Rated current: 32 A — Verify it in the project documentation before confirming the order.
• Rated surge voltage: 4 kV — Verify it in the project documentation before confirming the order.
• Clamping units: 5 — Verify it in the project documentation before confirming the order.

Cross-check the ratings above with the installed device before confirming the order.

Common questions about 222-415