WAGO 751-9301 Compact Controller 100

WAGO · Compact Controller 100

751-9301 is a WAGO Compact Controller 100. Enclosure rating: IP20; Operating temperature: -25 … +60 °C; Mounting: DIN-35 rail; Conformity marking: CE; UKCA. It is used in control panels, machine builds and spare-part replacements where the installed unit is matched to the original catalog number and a documented part is required.

• Enclosure ratingIP20
• Operating temperature-25 … +60 °C
• MountingDIN-35 rail
• Conformity markingCE; UKCA
• Supply voltage (system)24 VDC (-15 … +20 %); via wiring interface ( picoMAX ® 3.5; Push-in CAGE CLAMP ® connection)

Specifications

Values follow the WAGO official technical data published for catalog number 751-9301; parameters not confirmed for this variant are omitted rather than estimated.

Model comparison in the same family

Before selecting an alternative, confirm its dimensions, terminals and installation requirements in the manufacturer documentation.

Where it sits in the control system

The 751-9301 is the device-level element in a WAGO Compact Controller 100 installation. It receives the field signals and control supply listed above and switches or conditions the load within the ratings shown in the Specifications table. Wiring and protective devices are sized against enclosure rating IP20, operating temperature -25 … +60 °C, mounting DIN-35 rail — not against a generic assumption.

Typical installations place it in control panels, machine builds and spare-part replacements, where the unit is matched to the original catalog number and the enclosure provides the mounting support listed above. Record the catalog number and revision from the nameplate of the installed unit before specifying a like-for-like spare.

Selection notes for WAGO 751-9301

WAGO 751-9301 — WAGO industrial component supplied as a like-for-like replacement, selected by catalog number and published ratings. The figures below are taken from the WAGO official specification for catalog number 751-9301; always cross-check the catalog number and hardware revision on the nameplate before placing an order.

• Enclosure rating: IP20 — Verify it in the project documentation before confirming the order.
• Operating temperature: -25 … +60 °C — Verify it in the project documentation before confirming the order.
• Mounting: DIN-35 rail — Verify it in the project documentation before confirming the order.
• Conformity marking: CE; UKCA — Verify it in the project documentation before confirming the order.
• Supply voltage (system): 24 VDC (-15 … +20 %); via wiring interface ( picoMAX ® 3.5; Push-in CAGE CLAMP ® connection) — Verify it in the project documentation before confirming the order.

Cross-check the ratings above with the installed device before confirming the order.

Common questions about 751-9301