Omron · Total counter (DIN48x24)
H7GP-C is an Omron DIN48 x 24 total counter with Supply voltage AC 100 to 240 V (50/60 Hz); Enclosure IP66, oil resistant (panel face); Mounting Panel flush mounting, DIN48 x 24. It is used in panel-mounted totalising in industrial control equipment. The installed unit should be matched to the original catalog number.
-
FunctionTotal counter
-
Supply voltageAC 100-240 V
-
EnclosureIP66 oil resistant
-
MountingPanel flush (48x24)
Specifications
| Electrical |
| Supply voltage |
AC 100 to 240 V (50/60 Hz) |
| Power consumption |
AC 6.5 VA max |
| Mechanical |
| Mounting |
Panel flush mounting |
| Panel cutout |
DIN48 x 24 mm |
| Enclosure |
IP66, oil resistant (panel face only) |
Values are taken from the OMRON catalog for this catalog number; parameters not published by the manufacturer are not stated here.
Model comparison in the same family
| Omron DIN48 x 24 total counter variants |
| Catalog number |
Mounting |
|
H7GP-C (this page) |
Panel flush |
| H7GP-CD |
Refer to catalog |
| H7GP-CDB |
Refer to catalog |
| H7GPTD |
Refer to catalog |
Before selecting an alternative, confirm its dimensions, terminals and installation requirements in the manufacturer documentation.
Where it sits in the control system
The H7GP-C is the device-level element in an Omron installation. It is selected by catalog number and mounted or connected as specified in the manufacturer documentation.
A typical installation places it in panel-mounted totalising in industrial control equipment. Record the catalog number and revision from the nameplate of the installed unit before specifying a like-for-like spare.
Selection notes for Omron H7GP-C
Omron H7GP-C — selected by catalog number and manufacturer data. Confirm the nameplate data of the unit being replaced before selecting an equivalent.
- Supply voltage: AC 100 to 240 V (50/60 Hz) — Confirm against the installed nameplate and current datasheet.
- Enclosure: IP66, oil resistant (panel face) — Confirm against the installed nameplate and current datasheet.
- Mounting: Panel flush mounting, DIN48 x 24 — Confirm against the installed nameplate and current datasheet.
Cross-check the data above with the installed device before confirming the order.
Common questions about H7GP-C
Q.Where can I confirm the catalog data for H7GP-C?
The manufacturer data for H7GP-C is referenced on this page. Verify it against the installed nameplate and the latest OMRON documentation before ordering.
Q.What should I include in an enquiry for H7GP-C?
Send the full catalog number H7GP-C, the required quantity and a photo of the nameplate. Stock, lead time and compliance documents can then be confirmed.
Q.How do I confirm compatibility of H7GP-C before ordering?
Match the catalog number H7GP-C and the manufacturer data against the installed unit, and confirm the hardware or firmware revision where relevant.
Q.Are substitutes available for H7GP-C?
Alternatives are listed only where the catalog number and manufacturer data can be matched. Confirm any substitute against the installed unit before selection.
Q.What does H7GP-C belong to?
H7GP-C is an Omron DIN48 x 24 total counter. Use the catalog number to confirm the exact variant you need.